PC & Gadgets– category –
-
PC & Gadgets
Sony A7 IV USB Streaming Stuck at 720p? Check the USB Connection First
If your Sony A7 IV (ILCE-7M4) will only stream 720p over its built-in USB Streaming mode, check the USB connection before anything else. Sony documents that a USB 2.0 connection restricts the USB stream to 720p at 30p or 25p. A 720p 30p ... -
PC & Gadgets
Shure MV7i Second XLR Mic: Step-by-Step Setup to Record Both Voices
Yes, the Shure MV7i can record a second XLR microphone without a separate audio interface. Plug the guest mic into the combo XLR/¼-inch input on the back of the MV7i, connect the MV7i to your Windows PC with one USB-C cable, and control ... -
PC & Gadgets
CalDigit TS4 Second Monitor Not Detected on Windows? Check the Host, Ports, and Settings
If your CalDigit TS4 shows one monitor on a Windows PC but the second stays dark or never appears in Settings, check the PC before blaming the dock. CalDigit says Windows Thunderbolt 3 and Thunderbolt 4 PCs can run up to two displays thr... -
PC & Gadgets
APC BR1500MS2 Replace Battery Warning? What to Check Before Buying
If your APC Back-UPS Pro BR1500MS2 shows the Replace Battery icon, the official manual identifies an aging battery. Once you have confirmed the warning and ruled out damage or a separate hardware fault, arrange replacement with the match... -
PC & Gadgets
BenQ PD3225U USB-C No Signal on Mac? Check the Thunderbolt Port First
If your Mac charges from a BenQ PD3225U but the monitor shows no signal, the charging only proves that power is getting through — not video. Check three things first: the cable must go into the monitor's Thunderbolt 3 input (not the Thun... -
PC & Gadgets
Epson LS11000 No Signal at 4K120 on PC? Check HDMI and EDID
If your Epson Home Cinema LS11000 goes blank or shows a No Signal message only when a Windows PC sends 4K at 120Hz, treat it as a signal-path problem before you suspect the projector. First confirm the projector can display its own menu.... -
PC & Gadgets
ScanSnap iX1600 Not Connecting to Wi-Fi on Windows? Step-by-Step Fix
If your ScanSnap iX1600 won't connect over Wi-Fi to a Windows PC, or the touch panel shows "The device is not responding." when everything looks connected, start by checking four links: the scanner's connection to your access point, the ... -
PC & Gadgets
Anker Prime 250W Not Reaching 140W? Check C1, Cable, and Laptop Limits
Quick answer: If your Anker Prime Charging Station (250W, model A2345) shows far less than 140W for your laptop, that reading can be normal. The 250W rating is the total shared across all six ports, not the output of a single port. Only ... -
PC & Gadgets
Shure SM7dB No Sound or Low Input? Check +48V, Bypass, and Routing
If your Shure SM7dB shows no signal or a weak signal on a Windows PC, check the chain around the mic before assuming it is faulty. The SM7dB has a built-in preamp, and Shure is explicit about what it needs: "All you need is an interface ... -
PC & Gadgets
BenQ SW272U USB-C No Signal? Check the Input, Cable, and 4K Mode
If your BenQ SW272U shows no signal over USB-C from a Windows laptop, start with the signal path before suspecting the panel. Check these three things in order: The monitor input is set to USB-C (Display → Input in the on-screen menu). T...
